Methods of creating stitching data
(3) Circle input
Operation points
* Designate circle input ( )
* Input three points (A circle, passing through the current position (already input) and two
newly input points, is created.)
Note that the work holder will go back to the circle start position after the data is created.
[Example] The following type of pattern data will be created.
Operation details
1. Inputting feed data to A point
* Press and on
the Standard screen. After making the
various settings on the Data Setting
Input screen, the Arrow Input screen
will open.
* Check that the code is set to FEED.
If different code is set, press
and set the code to FEED.
* Press the arrow keys and move to the
A point.
(Feed data to A point.)
2. Setting feed data to A point
* The movement amount can be
confirmed.
* Press to set the data.
(Data on feed data to point A will be
created.)
* Feed data to the A point will be set.
* To change the stitching type to "Circle
input", press the input method setting
key.
(In this case, the key.)
[9]-8
To Next Page
Loading...
Need help?
General
