Reading, writing and erasing data (floppy disk)
[5]-4
2. Changing between internal memory and floppy disk
* In the same manner as when reading
data, the default mode when the
screen is opened is the internal
memory mode. Change to the floppy
disk mode. (Refer to steps 2 and 3 for
reading data.)
[Memo] If a floppy disk is not inserted, a
message indicating this will appear.
3. Selecting and erasing data
* Press (select) the number of the data
to
be erased, and press .
* A message confirming the erasing will
appear.
To cancel the erasing process,
press .The data will not be
erased, and the Read screen will
reappear.
To erase the data, press .
After a message indicating the erasing
in progress appears, the Standard
screen will reappear.
To Next Page
Loading...
