Methods of creating stitching data
[9]-27
2. Setting the back tacking details
* The details are set on this screen.
(The details set here are,
(start/end back tacking)), start mode
(N mode), three start stitches, end
mode (N mode), three end
stitches.)
* Press to determine these set
values.
* The system will return to the input
method setting screen.
* Press to determine the set
values.
* The system will return to the arrow
input screen.
* Determine the B point with the linear
input procedures, and create a linear
line.
(A straight line having start back
tacking and end back tacking will be
created.)
* After creating the linear line,
input .
3. Confirming the data
* The start/end back tacking data for the
linear line has been created.
Memo Regarding back tacking mode Memo Regarding number of stitches
V mode: Back tacking will be performed Press the key of the desired position
only once.
N mode: Back tacking will be performed ( or ) to invert the key.
twice.
M mode: Back tacking will be performed After that, set data using the numeric keys
third.
W mode: Back tacking will be performed or .
fourth.
To Next Page
Loading...
