Methods of creating stitching data
* After creating the broken line data,
input .
[9]-29
3. Confirming the data
* The overlap back tacking will be
created with the rectangle made with
broken lines.
Memo Overlap mode
in the overlap mode indicate the number of overlapped sections.
Memo Number of overlap stitches
This is the number of stitches at the overlapped section. (Set a value between 0 and 9.)
Memo If the distance between the broken line start point and the end point is 0.5 mm or more, the
overlap back tacking data will not be created.(If the distance between the broken line start point
and the end point is less than 0.5, the pattern will be regarded as the "closed pattern", and the
same coordinate value will be automatically set for both the start point and end point.)
To Next Page
Loading...
