Chapter Six: Remote Operation How To Activate the Learn Function
71
How To Stop the Learn Function
It is recommended that the learn function go through to completion. However, if your process is
slow to reach its highest pressures
and
your process will not be operating at those pressures, it is
possible to stop the learn function early.
Caution
Do not stop the learn function until it is well above the highest
pressure at which the process will be operating.
•
To stop the learn function, issue the command:
Q
ENTER
The system responds by stopping the learn function and returning to its prior operation. For
example, if the valve was closed before the learn function was initiated, the valve will now close.
To Next Page
Loading...
