Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies Sec 1: 8-25
8.8.6 Servicing of Expansion Board Assembly
1. Complete steps 8.7.1 through 8.7.3 of Section “8.7 Radio Disassembly” on page 1:8-12.
Figure 8-34. Expansion Board Assembly
NOTE: There are no serviceable components on the Expansion Board Assembly.
8.8.7 Servicing Back Chassis Assembly (E) – Dual Display Version
1. Complete steps 8.7.1 through 8.7.5 of Section “8.7 Radio Disassembly” on page 1:8-12.
Figure 8-35. Back Chassis Assembly (Dual Display Version)
NOTE: Take care not to damage the Color Display during disassembly.
8.8.7.1 Servicing Color Display
1. Disconnect the Back Chassis Flex from the back of the Color Display (35).
2. Gently pry the Color Display out of the Back Chassis Assembly (20) by using the Black Stick
against the white section of the frame (upper left corner at the back of the Color Display).
3. Remove any remnants of the Display's Pad if it does not come off completely with the Color
Display from the back Chassis Assembly.
Take care not to damage the Back Chassis seal while
servicing the Back Chassis.
Expansion Board Assembly (C)
Color Display (35)
Back Chassis Assembly (20)
Speaker Seal (21)
Lens (22)
To Next Page
Loading...
