Sec 1: 8-14 Disassembly/Reassembly Procedures: Radio Disassembly
Figure 8-17. Remove Flex Connectors and Expansion Board Assembly
2. Remove the Expansion Board Assembly (C) by gently lifting up the right side of the PCB as
shown in Figure 8-17.
3. If the VOCON Board Assembly (G, N) is to be removed from the Control Top Assembly (J),
then remove the Connector Plug (32) with the Black Stick and unplug the Control Top
Assembly flex as shown in Figure 8-17.
If the radio is equipped with an Option Board Assembly in lieu of the Connector Plug (32):
i. rotate the Option Board locking levers to unlock the option board and free it for removal
as shown in Figure 8-18.
ii. unplug the Option Board Assembly from the VOCON Board Assembly by using the
Black Stick as shown in Figure 8-19.
Figure 8-18. Unlock Levers
Figure 8-19. Remove Option Board
Flex Connectors
Expansion Board Assembly (42)
Connector Plug (32)
Locking Levers
Option Board
To Next Page
Loading...
