Motorola APX 7000 - Identifying Status Indicators; LED Indicator

Performance Checks: Top-Display Version Radio Test Mode Sec 1: 5-7
- Press 7, “55/1” appears; release, “55/0” appears.
- Press
8, “56/1” appears; release, “56/0” appears.
- Press
9, “57/1” appears; release, “57/0” appears.
- Press
*, “58/1” appears; release, “58/0” appears.
- Press
#, “59/1” appears; release, “59/0” appears.
- Press
<, “128/1” appears; release, “128/0” appears.
- Press
H, “129/1” appears; release, “129/0” appears.
- Press
>, “130/1” appears; release, “130/0” appears.
- Press
{, “131/1” appears; release, “131/0” appears.
- Press
|, “132/1” appears; release, “132/0” appears.
- Press
}, “133/1” appears; release, “133/0” appears.
- Press
P, “134/1” appears; release, “134/0” appears.
- Press
U, “135/1” appears; release, “135/0” appears.
- Press
D, “136/1” appears; release, “136/0” appears.
5.3 Top-Display Version Radio Test Mode
This section provides instructions for performing tests in non-display radio test mode.
5.3.1 Access the Test Mode
To enter the non-display radio test mode:
1. Turn the radio on.
2. Within 10 seconds after the top red LED turns off, press Side button 2 five times in
succession.
3. Do one of the following:
• Press the Top Side Button to put the radio into the Control Top and Keypad test mode.
Go to “5.3.3 Control Top Test Mode” below.
NOTE: Each press of the Top Side Button toggles between Control Top and Keypad test
mode (non-display radio) and RF test mode (non-display radio).
•Press the Top Button (Orange button) to put the radio into the RF test mode. Go to “5.3.2
RF Test Mode” below.