Motorola APX 7000 Basic Service Manual

List of Figures Sec 1: vii
Figure 8-4. Removing the Antenna ...................................................................................................... 1:8-6
Figure 8-5. Attaching Battery – Battery Seal........................................................................................ 1:8-7
Figure 8-6. Attaching Battery – Memory Door......................................................................................1:8-8
Figure 8-7. Attaching Battery – Slide into Position ............................................................................... 1:8-8
Figure 8-8. Squeezing the Release Latches ........................................................................................1:8-9
Figure 8-9. Removing the Battery ........................................................................................................ 1:8-9
Figure 8-10. Removing the Thumb Screw............................................................................................1:8-10
Figure 8-11. Engaging Hook and Seating Cover.................................................................................. 1:8-11
Figure 8-12. Securing the Cover .......................................................................................................... 1:8-11
Figure 8-13. Remove Center Screws ................................................................................................... 1:8-12
Figure 8-14. Remove Bottom Screws .................................................................................................. 1:8-12
Figure 8-15. Remove Top Screws ........................................................................................................ 1:8-13
Figure 8-16. Remove Speaker Module ................................................................................................ 1:8-13
Figure 8-17. Remove Flex Connectors and Expansion Board Assembly ............................................ 1:8-14
Figure 8-18. Unlock Levers .................................................................................................................. 1:8-14
Figure 8-19. Remove Option Board ..................................................................................................... 1:8-14
Figure 8-20. Remove Antenna Coax Cable Connector........................................................................ 1:8-15
Figure 8-21. Remove Housing ............................................................................................................. 1:8-15
Figure 8-22. Remove Back Chassis Assembly from Main Chassis Assembly..................................... 1:8-16
Figure 8-23. Remove RF Board Assembly........................................................................................... 1:8-17
Figure 8-24. Remove VOCON Board Assembly .................................................................................. 1:8-18
Figure 8-25. Remove Knobs and Fastener Hardware.......................................................................... 1:8-19
Figure 8-26. Remove Control Top Bezel Assembly.............................................................................. 1:8-19
Figure 8-27. Remove Control Top Assembly (9) .................................................................................. 1:8-19
Figure 8-28. Serviceable Components – Main Chassis Assembly....................................................... 1:8-20
Figure 8-29. Remove Chassis Ground Contact ................................................................................... 1:8-22
Figure 8-30. Control Top Assembly and Control Top Seal ................................................................... 1:8-22
Figure 8-31. Top Bezel Assembly......................................................................................................... 1:8-23
Figure 8-32. VOCON Board Assembly................................................................................................. 1:8-23
Figure 8-33. RF Board Assembly ......................................................................................................... 1:8-24
Figure 8-34. Expansion Board Assembly ............................................................................................. 1:8-25
Figure 8-35. Back Chassis Assembly (Dual Display Version) .............................................................. 1:8-25
Figure 8-36. Back Chassis Assembly (Top Display Version)................................................................ 1:8-27
Figure 8-37. Main Housing Assembly (Dual Display Version).............................................................. 1:8-27
Figure 8-38. Main Housing Assembly (Top Display Version) ............................................................... 1:8-28
Figure 8-39. Speaker Module ............................................................................................................... 1:8-29
Figure 8-40. Speaker Grille Assembly.................................................................................................. 1:8-30
Figure 8-41. Control Top Bezel Assembly ............................................................................................ 1:8-31
Figure 8-42. Top Bezel Assembly......................................................................................................... 1:8-31
Figure 8-43. Inspect Pads .................................................................................................................... 1:8-32
Figure 8-44. Insert VOCON Board ....................................................................................................... 1:8-33
Figure 8-45. Connect RF Board to VOCON Board .............................................................................. 1:8-33
Figure 8-46. Place Back Chassis ......................................................................................................... 1:8-34
Figure 8-47. Place Housing into Main Chassis .................................................................................... 1:8-34
Figure 8-48. Assemble Expansion Board Assembly ............................................................................ 1:8-35
Figure 8-49. Insert Flex Connectors..................................................................................................... 1:8-35
Figure 8-50. Assemble Option Board................................................................................................... 1:8-36
Figure 8-51. Lock Levers...................................................................................................................... 1:8-36
Figure 8-52. Lubricate Main Chassis.................................................................................................... 1:8-36
Figure 8-53. Insert Speaker Module ..................................................................................................... 1:8-37
Figure 8-54. Insert Top Screws ............................................................................................................ 1:8-37
Figure 8-55. Remove Center Screws ................................................................................................... 1:8-38
Figure 8-56. Insert Center Screws ....................................................................................................... 1:8-38
Figure 8-57. Insert Bottom Screws....................................................................................................... 1:8-38

Motorola APX 7000 Specifications

General

Digital Technology	P25 Phase 1 and Phase 2
Emergency Button	Yes
Frequency Range	136-174 MHz (VHF), 380-470 MHz (UHF Range 1), 450-520 MHz (UHF Range 2), 764-870 MHz (700/800 MHz)
Display	Color LCD
Encryption	AES, DES
Water Resistance	IP67
GPS	Yes
Bluetooth	Yes
Operating Temperature	-30°C to +60°C
Weight	391 g (with standard battery)