Motorola APX 7000 Basic Service Manual

Sec 1: 5-4 Performance Checks: Display Radio Test Mode (Dual-Display Version)
NOTE: All displays are temporary and will expire without any user intervention. If
information is longer than the physical length of the radio’s display, the information
will wrap around to the next display. After the last display, “RF TEST” is displayed.
To freeze any of the displays, press the left arrow on the 4-Way Navigation Button.
To resume automatic scrolling, press the right arrow on the 4-Way Navigation
Button. To rapidly scroll forward through the displays, continue pressing the right
arrow. You cannot scroll backwards.
NOTE: Press the Top side (purple) button to advance the test environments from “RF
TEST”, “CH TEST”, “RGB TEST”, “CID TEST” then press the orange button to
confirm selection. Press any other buttons to advance the test.
Once a test is carried out, restart the radio to proceed to another test.
3. Do one of the following:
•Press the Top Side Button to stop the displays and toggle between RF test mode and the
Control Top and Keypad test mode. The test mode menu “CH TEST” is displayed,
indicating that you have selected the Control Top and Keypad test mode. Go to Section
“5.2.3 Control Top and Keypad Test Mode” on page 1:5-6.
NOTE: Each press of the Top Side Button will toggle between “CH TEST” and “RF TEST”.
•Press the Top Button (Orange button) to stop the displays and put the radio into the RF
test mode. The test mode menu, “1 CSQ”, is displayed, indicating test frequency 1
, Carrier
SQ
uelch mode. Go to Section “5.2.2 RF Test Mode” below.
NOTE: Once your radio is in a particular test mode, you must turn off the radio and turn it
back on again to access the other test mode.
FLASHcode The FLASH codes as programmed in the
codeplug
Always
RF band 1 The radio’s operating frequency Always
RF band 2 The radio’s operating frequency When the radio has more than 1
operating frequency
Tuning ver Version of Tuning codeplug Always
Proc ver Version of Processor Always
Option Board Type Type of Option Board in the radio When the radio is equipped with
an Option Board
Option Board
Bluetooth Addr
Address of the Bluetooth IC When the radio is equipped with
a Bluetooth Option Board
Option Board SW
Version
Version of Option Board software When the radio is equipped with
an Option Board
Table 5-2. Test-Mode Displays (Continued)
Name of Display Description Appears

Motorola APX 7000 Specifications

General

Digital Technology	P25 Phase 1 and Phase 2
Emergency Button	Yes
Frequency Range	136-174 MHz (VHF), 380-470 MHz (UHF Range 1), 450-520 MHz (UHF Range 2), 764-870 MHz (700/800 MHz)
Display	Color LCD
Encryption	AES, DES
Water Resistance	IP67
GPS	Yes
Bluetooth	Yes
Operating Temperature	-30°C to +60°C
Weight	391 g (with standard battery)