7 - 10 DS9208 Product Reference Guide
Stop Bits
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. Select the number of stop bits
(one or two) based on the number the receiving terminal is programmed to accommodate. Set the number of
stop bits to match host device requirements.
Data Bits
This parameter allows the digital scanner to interface with devices requiring a 7-bit or 8-bit ASCII protocol.
*1 Stop Bit
2 Stop Bits
7-Bit
*8-Bit
To Next Page
Loading...
