Symbologies 10 - 61
MSI
Enable/Disable MSI
Parameter # 11
To enable or disable MSI, scan the appropriate bar code below.
Set Lengths for MSI
Parameter # L1 = 30, L2 = 31
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set lengths for MSI to any length, one or two discrete lengths, or lengths within a
specific range. The default option is Length Within Range, 4 to 55.
•
One Discrete Length - Decode only MSI symbols containing a selected length. Select the length using
the bar codes in Appendix G, Numeric Bar Codes. For example, to decode only MSI symbols with 14
characters, scan MSI - One Discrete Length, and then scan 1, 4. To correct an error or to change the
selection, scan Cancel on page G-2.
•
Two Discrete Lengths - Decode only MSI symbols containing either of two lengths. Select lengths
using the bar codes in Appendix G, Numeric Bar Codes. For example, to decode only MSI symbols
containing either 2 or 14 characters, select MSI - Two Discrete Lengths, and then scan 0, 2, 1, 4. To
correct an error or to change the selection, scan Cancel on page G-2.
•
Length Within Range - Decode MSI symbols with a specific length range. Select lengths using bar
codes in Appendix G, Numeric Bar Codes. For example, to decode MSI symbols containing between
4 and 12 characters, first scan MSI - Length Within Range, and then scan 0, 4, 1, 2. To correct an
error or change the selection, scan Cancel on page G-2.
•
Any Length - Decode MSI symbols containing any number of characters within the digital scanner’s
capability.
Enable MSI
(1)
*Disable MSI
(0)
NOTE When setting lengths, enter a leading zero for single digit numbers.
To Next Page
Loading...
