10 - 28 DS9208 Product Reference Guide
Set Lengths for Code 128
Parameter # L1 = 209, L2 = 210
The length of a code refers to the number of characters (i.e., human readable characters), including check
digit(s) the code contains. Set lengths for Code 128 to any length, one or two discrete lengths, or lengths within
a specific range. The default is Any Length.
•
One Discrete Length - Decode only Code 128 symbols containing a selected length. Select the length
using the bar codes in Appendix G, Numeric Bar Codes. For example, to decode only Code 128 symbols
with 14 characters, scan Code 128 - One Discrete Length, and then scan 1, 4. To correct an error or
change the selection, scan Cancel on page G-2.
•
Two Discrete Lengths - Decode only Code 128 symbols containing either of two lengths. Select
lengths using the bar codes in Appendix G, Numeric Bar Codes. For example, to decode only Code 128
symbols containing either 2 or 14 characters, select Code 128 - Two Discrete Lengths, and then
scan 0, 2, 1, 4. To correct an error or change the selection, scan Cancel on page G-2.
•
Length Within Range - Decode Code 128 symbols with a specific length range. Select lengths
using the bar codes in Appendix G, Numeric Bar Codes. For example, to decode Code 128 symbols
containing between 4 and 12 characters, scan Code 128 - Length Within Range, and then scan 0, 4, 1,
2. To correct an error or change the selection, scan Cancel on page G-2.
•
Any Length - Decode Code 128 symbols containing any number of characters within the digital
scanner’s capability.
NOTE When setting lengths, enter a leading zero for single digit numbers.
Code 128 - One Discrete Length
Code 128 - Two Discrete Lengths
Code 128 - Length Within Range
*Code 128 - Any Length
To Next Page
Loading...
