Motorola DS9208 - Appendix A Standard Default Parameters

APPENDIX A STANDARD DEFAULT
PARAMETERS
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter N/A Set Defaults 4-4
Parameter Bar Code Scanning 236 Enable 4-5
Beep After Good Decode 56 Enable 4-5
Beeper Tone 145 Medium 4-6
Beeper Volume 140 High 4-7
Volume Adjustment Trigger Timeout 403 5.0 Sec 4-8
Beeper Duration 628 Medium 4-9
Suppress Power-up Beeps 721 Do not suppress 4-9
Low Power Mode 128 Disable 4-10
Time Delay to Low Power Mode 146 1 Hour 4-11
Trigger Mode 138 Presentation 4-13
Trigger Aiming Pattern 306 Enable 4-14
Presentation Aiming Pattern 590 Disable 4-15
Momentary Trigger Mode Timeout 237 5 sec 4-16
Motion Detect Range 827 Full 4-17
Decoding Illumination
(Hand-Held Mode Only)
298 Enable 4-18
1
User selection is required to configure this interface and this is the most common selection.