Motorola DS9208 - Trigger Aiming Pattern

4 - 14 DS9208 Product Reference Guide
Trigger Aiming Pattern
Parameter # 306
Select Enable Trigger Aiming Pattern to project the aiming pattern during bar code capture in trigger mode,
or Disable Trigger Aiming Pattern to turn the aiming pattern off.
This parameter does not apply to Snapshot Mode. See Operational Modes on page 5-4.
NOTE With Picklist Mode on page 4-23 enabled, the decode aiming pattern flashes even when the Decode
Aiming Pattern is disabled.
*Enable Trigger Aiming Pattern
(2)
Disable Trigger Aiming Pattern
(0)