Motorola DS9208 - Errors While Scanning; Symbology Parameter Defaults

10 - 2 DS9208 Product Reference Guide
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 10-1 lists the defaults for all symbologies parameters. To change the default values, scan the appropriate
bar codes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan the Set Default Parameter on page 4-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, and miscellaneous default
parameters.
Table 10-1 Parameter Defaults
Parameter
Parameter
Number
Default
Page
Number
Disable All Code Types 10-8
UPC/EAN
UPC-A 1 Enable 10-9
UPC-E 2 Enable 10-9
UPC-E1 12 Disable 10-10
EAN-8/JAN 8 4 Enable 10-10
EAN-13/JAN 13 3 Enable 10-11
Bookland EAN 83 Disable 10-11
Bookland ISBN Format 576 ISBN-10 10-12
Decode UPC/EAN/JAN Supplementals (2 and 5 digits) 16 Ignore 10-14
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
579
580
N/A 10-16
UPC/EAN/JAN Supplemental Redundancy 80 10 10-16
Decode UPC/EAN/JAN Supplemental AIM ID 672 Combined 10-17
UPC Reduced Quiet Zone 1289 Disable 10-18
Transmit UPC-A Check Digit 40 Enable 10-18
Transmit UPC-E Check Digit 41 Enable 10-18
Transmit UPC-E1 Check Digit 42 Enable 10-19
UPC-A Preamble 34 System Character 10-20
UPC-E Preamble 35 System Character 10-21