MSENSE
®
DGA 9 7045899/02 EN – 11.2020 Page 31
• Apply LOCTITE
®
7471 (activator) by spraying or brushing it onto both sealing faces. During
spraying, the openings (transformer gate valve and MSENSE
®
DGA 9) must be covered/sealed
by a clean cloth / paper towel.
• Allow the activator to flash off completely in a well ventilated room until the surface is completely
dry.
Remark: After activation, the thread connection should be glued within 7 days at the latest. Soiling
should be avoided before gluing.
• Apply LOCTITE
®
577 (adhesive) 360° in a ring shape on 3 to 4 thread grooves of the external
thread, leaving the first thread groove clear.
• Use suitable gloves so that you can apply the adhesive to the bottom of the thread groove,
filling the intermediate spaces well.
Remark: Adapt the adhesive quantity accordingly in the case of larger intermediate spaces.
To Next Page
Loading...
