MSENSE
®
DGA 9 7045899/02 EN – 11.2020 Page 8
2. Safety
This technical file contains detailed descriptions to safely and properly install, connect, commission,
and monitor the product.
• Read this technical document carefully to familiarize yourself with the product.
• This technical document is part of the product.
• Read and pay special attention to the safety instructions in this chapter.
• Observe the warnings in this technical file in order to avoid dangers arising from the operation.
• The product is manufactured according to the state of the art. Nonetheless, dangers to the life
and limb of the user or impairments of the product and other material assets may occur due to
functional use.
Intended Use
The MSENSE® DGA is intended exclusively for use in systems and facilities of electrical power engi-
neering. It is used for the early detection and reporting of evolving, potentially harmful trends in the
monitored equipment (e.g., transformer) by measuring the concentration of gases and moisture in the
equipment's insulating oil.
The device is not designed and is not capable of detecting very fast developing faults and thus not
intended to protect the device from such faults (e.g., by shutting down). For this purpose, please use
safety devices designed for this purpose.
Proper use and compliance with the conditions and conditions specified in this technical file as well as
the warnings contained in this technical documentation and on the product do not pose a risk to per-
sons, property and equipment
Environment. This applies over the entire service life, from delivery to assembly and operation to dis-
assembly and disposal.
The intended use is as follows:
• Operate the product according to this technical document, the agreed terms of delivery and the
technical data.
• Make sure that all necessary work is done by qualified personnel only.
• Use the devices supplied only for the intended purpose and in accordance with the specifica-
tions of this technical document.
• Observe the notes in this technical document for electromagnetic compatibility and the technical
data.Safety
Basic safety instructions
In order to prevent accidents, breakdowns, accidents and environmental damage, the person respon-
sible for the transport, installation, operation, maintenance and disposal of the product or parts of the
product must ensure that:
To Next Page
Loading...
