MSENSE
®
DGA 9 7045899/02 EN – 11.2020 Page 6
1. Introduction
This technical file contains detailed descriptions to safely and properly install, connect, commission,
and monitor the product.
The target group of this technical document is exclusively specially trained and authorized specialist
personnel.
Contact
Your contact for all inquiries about the MSENSE® DGA 9:
MR Service & Complaint
Maschinenfabrik Reinhausen GmbH
Falkensteinstraße 8
93059 Regensburg
Germany
service@reinhausen.com
complaint@reinhausen.com
If required, you will receive further information on the product and issues of this technical document at
this address.
The MSENSE® DGA 9 is manufactured for Maschinenfabrik Reinhausen GmbH by:
EMH Energie-Messtechnik GmbH
Vor dem Hassel 2
D-21438 Brackel
Germany
MTE Meter Test Equipment AG
Landis + Gyr-Strasse 1
CH-6300 Zug
Switzerland
Revision Rights
The information contained in this technical document is the technical specifications released at the time
of printing. Significant changes will be reflected in a new edition of the technical file.
Document name and version number of this technical document can be found in the footer.
Completeness
This technical document is only complete together with the other applicable documents.
The following documents apply to this product:
• Installation and Operating Instructions MSENSE® DGA 9 (this document)
• Operating Instructions MSET DGA Software
• Test report
To Next Page
Loading...
