Configuring the terminal in the Service application
GPS receiver
7
30302710-02-EN V7.20141016 37
▪ Name of the satellite. Which satellites are shown here is dependent on the driver and correction
signal that you have activated.
Steering
This parameter activates the "Automatic steering" assistance function in the GPS receiver.
If you want to connect your existing GPS receiver to a steering job computer, you have to configure
the "Steering" parameter.
Potential values:
▪ "On"
Activates automatic steering assistance.
▪ "Off"
Deactivates automatic steering assistance.
Correction signal
Type of correction signal for the DGPS receiver.
The correction signals which are available is dependent on the activated driver.
Potential values:
▪ For the "A100, A101" driver:
– "WAAS/EGNOS"
Correction signal for Europe, North America, Russia and Japan.
– "E-DIF"
Internal calculation of correction data.
Only functions with a special version of the A100 DGPS receiver, item no. 30302464. This
receiver is no longer sold by Müller-Elektronik.
▪ For the "AG-STAR, SMART-6L" driver
When a AG-STAR DGPS/Glonass receiver is connected:
– "EGNOS-EU"
– "WAAS-US"
– "MSAS-JP"
– "EGNOS-EU + GL1DE"
– "WAAS-US + GL1DE"
– "MSAS-JP + GL1DE"
– "GPS/Glonass GL1DE 1"
– "GPS/Glonass GL1DE 2"
When a SMART-6L DGPS/Glonass receiver is connected:
– EGNOS/WAAS
– EGNOS/WAAS + GL1DE
– GL1DE
– RTK radio (RTK license required [➙ 38])
– RTK GSM (RTK license required [➙ 38])
Correction signal format
To Next Page
Loading...
