Configuring the terminal in the Service application
Configuring farmpilot
7
30302710-02-EN V7.20141016 53
Username
User name for farmpilot.
Password
Password for farmpilot.
Provider
Opens a screen where the GPRS connection can be configured.
With most mobile phone providers, this configuration occurs automatically.
If the access data for the GPRS connection differ with your provider, you can configure the
connection manually.
You can find precise instructions in the chapter:
Configuring the GPRS connection manually [➙ 53]
Server
Server address
The server address cannot be altered.
Log
Switches logging on and off.
Switch on logging only when prompted to do so by Customer Services.
Configuring the GPRS connection manually
In this chapter you will learn how to configure the GPRS connection manually.
With most SIM cards, the GPRS connection will be configured automatically.
The GPRS connection must be manually configured in the following instances:
▪ You have bought a new SIM card. The terminal does not recognize your mobile phone provider.
▪ Your mobile phone provider has altered the access data for the GPRS connection.
The values you must enter for the parameters, depend on your mobile phone provider. You can find
out these data from your mobile phone provider.
You will require the following parameters for the configuration:
Country
Country for which the SIM card is configured. Cannot be altered.
Provider
Name of the mobile phone provider. Appears automatically.
With unrecognized cards, you can enter the name of the mobile phone provider yourself.
APN
Abbreviation of "Access Point Name“.
Address of the GPRS access point.
DNS 1 and DNS 2
Abbreviation of "Domain Name System“.
To Next Page
Loading...
Need help?
General
