7
Configuring the terminal in the Service application
Configuring farmpilot
52 30302710-02-EN V7.20141016
⇨ The following screen will appear:
2. Click on "farmpilot".
3. Click on the "farmpilot" driver.
⇨ The following icon will appear next to the driver
4.
- Restart the terminal.
⇨ The following function icon will appear in the start screen of the "Service" application:
⇨ You have activated the farmpilot portal.
You must now enter the access data for the farmpilot portal.
Configuring the connection with farmpilot
Before you can connect the terminal to farmpilot, you must configure the connection.
You will receive this data when purchasing the farmpilot access data.
1. Open the "Service" application:
| Service
2.
- Open the access data screen for farmpilot.
⇨ The following screen will appear:
3. Click on the line with the desired parameter.
4. Configure parameter.
You will require the following parameters for the configuration:
To Next Page
Loading...
Need help?
General
