Muller Elektronik TRACK Guide II - Page 5

Contents
30302710-02-EN V7.20141016 5
8.2.1
Calibrating the speed sensor
61
8.2.2 Configuring a working position sensor 62
8.2.3
Entering the position of the GPS Receiver
63
For machines fitted with an ISOBUS job computer
64
8.3
Activating vehicle profiles
65
9
ISOBUS-TC task processing
66
9.1
Using ISOBUS-TC
66
9.2
Adjusting how you use ISOBUS-TC
66
9.3
Configuring the list of connections
67
10 Serial Interface application 69
10.1 Transfer target rates via LH5000 69
10.2 Switching sections and transferring target rates via ASD 70
11
File Server application
73
12
Maintenance and servicing
74
12.1
Servicing and cleaning the terminal
74
12.2
Disposing of the unit
74
12.3
Instructions on retrofitting
74
12.4
Checking the software version
75
12.5
Technical specifications
75
12.5.1
Technical specifications of the terminal
75
12.5.2
Pin assignment of port A
76
12.5.3
Pin assignment of port B
77
12.5.4 Pin assignment of port C 78
12.5.5
Pin assignment of camera ports 1 and 2
79
13
Notes
80