8
Tractor-ECU application
Configuring the parameters for a vehicle profile
60 30302710-02-EN V7.20141016
A working position sensor, is located on the front hitch or on the implement mounted on the front
hitch. It is connected to the terminal via connector B. The working position sensor must be
configured [➙ 62].
▪ "Rear via connector B"
A working position sensor, is located on the rear hitch or on the implement mounted on the front
hitch. It is connected to the terminal via connector B. The working position sensor must be
configured [➙ 62].
▪ "Unknown sensor via CAN"
There is a working position sensor determining the working position of the implement. It is
connected to an ISOBUS job computer or to a different terminal. The signal reaches the terminal
via CAN.
▪ "Front via CAN"
There is a working position sensor determining the working position of the implement at the front
of the vehicle. It is connected to an ISOBUS job computer or to a different terminal. The signal
reaches the terminal via CAN.
▪ "Rear via CAN"
There is a working position sensor determining the working position of the implement at the rear
of the vehicle. It is connected to an ISOBUS job computer or to a different terminal. The signal
reaches the terminal via CAN.
Direction
You can use these parameters to configure whether the terminal can receive a direction signal, and
the source from which it originates. When a direction signal is present, the TRACK-Leader application
can correctly mark the vehicle movement when travelling in reverse.
Potential values:
▪ "deactivated"
No direction sensor is connected to the terminal. If another ISOBUS device transmits a direction
signal, however, this is not blocked.
▪ "Unknown sensor via CAN"
The terminal is receiving a direction signal via CAN whose source is unknown.
▪ "Radar sensor via CAN"
A radar sensor with direction identification is connected to the terminal via CAN.
▪ "Wheel sensor via CAN"
A wheel sensor with direction identification is connected to the terminal via CAN.
▪ "Direction sensor"
A direction sensor is connected to the serial interface of the terminal. Does not function if a
working position sensor is connected to the terminal.
▪ "inversion"
This parameter inverts the meaning of the signals. Only for use with the "Direction sensor"
parameter.
Connection with ISOBUS-TC?
With this parameter, you can set whether the Tractor ECU application should communicate with the
ISOBUS-TC application. In doing so, it transmits: Counters, working position, position of the GPS
receiver.
Deactivate this parameter only if the terminal is used as a secondary terminal and the GPS receiver
is connected to a different terminal.
To Next Page
Loading...
Need help?
General
