MUTOH ValueCut VC2-1300 - Common Problems and Solutions

MAINTENANCE MANUAL
VC2E-MM-00
55
Problems and Solutions
This section describes the typical problems you may encounter while operating the cutting plotter and
offers you possible solutions.
The cutting quality is not good at the corner or the end point.
[Check item] [Action]
 Is the screw on holder loose? Tighten the screw firmly.
 Is the blade worn? Replace the blade.
 Is AAS offset value adjusted? Adjust the offset value.
 Is the media not flat enough? Reload the media.
 Is the media wet? Replace the media.
 Is the quality of media not good? Change the media.
 Is the drum or pinch roller worn? Replace the drum set or pinch roller.
The media width cannot be detected since the pinch roller position is not clear.
[Check item] [Action]
 Is the pinch roller lowered? Lower the lever and release the lock.
 Is the width sensor working? Adjust the board mounting position.
 Is the width sensor covered the flag? Check the board mounting position.
 Is the flat cable damaged? Replace the cable.
 Is the width sensor damaged? Replace the carriage board.
 Is the carriage board damaged? Replace the carriage board.
The function of "Set New Origin" does not work.
[Action]
Set a media on the ValueCut, and Press ENTER key when LCD displays the X/Y distance from the old
origin.