MAINTENANCE MANUAL
VC2E-MM-00
26
Note: When re-installing the Pinch roller set, the Cam roller must be aligned squarely to the Square Bar.
Note: When aligning the Cam roller, please remember to keep the release grip locked down.
Note: Pinch-roller is color-coded by pressure force. When replacing
the pinch-roller, make sure to replace all the pinch-rollers
with the same color.
Replacing Carriage Board
Please follow the steps below to replace the carriage board.
1. Depress the locking clips at the top of the tool carriage cover, and pull the cover away.
(It is easy to remove if you lift from the bottom)
To Next Page
Loading...
