MUTOH ValueCut VC2-1300 - Media Shifts Away When Plotting a Long Drawing; The Cutting Line Is Wavy; Data Are Missing When Plotting; Serious Error Occurs When Feeding Media

MAINTENANCE MANUAL
VC2E-MM-00
56
Media shifts away when plotting a long drawing.
[Check item] [Action]
 Is the media aligned accurately? Reload the media.
 Is the media pre-run with Jog key? Reload the media and pre-run.
 Is the media edge cut straightly? Change the media.
 Is the media too thin? Change the media.
 Is there any paper chips or dust on the drum? Clean the surface of drum.
 Is the drum or pinch roller worn? Replace the drum set or pinch roller.
The cutting line is wavy.
[Check item] [Action]
 Is the screw on holder loose? Tighten the screw firmly.
 Is the blade worn? Replace the blade.
 Is the acceleration set too high? Set the acceleration to a lower value.
 Is the carriage belt tension correct? Adjust the belt tension.
 Is X or Y motor belt tension correct? Adjust the belt tension.
 Is the carriage bearing or roller damaged? Replace the carriage.
 Is the media length too short in X direction? Change the media.
 Is the media too thin? Change the media.
 Is the drum or pinch roller worn? Replace the drum set or pinch roller.
 Is X or Y motors damaged? Replace the motor.
Data are missing when plotting.
[Check item] [Action]
 The memory chip may have a problem. Replace the main board.
Serious error occurs when feeding media.
[Check item] [Action]
 Are some media pulled out from the roll? Enable “Auto media feed” on the panel.
 Is X motor belt too tight? Adjust the belt tension.