MUTOH ValueCut VC2-1300 - Replacing Tool Carriage

MAINTENANCE MANUAL
VC2E-MM-00
28
Replacing Tool Carriage
Please follow the steps below to replace the tool carriage.
1. Loosen the 2 retaining screws (No need to remove them), and then turn
the 2 adjustment screws anti-clockwise to loosen the carriage belt.
Adjustment Screws
Retaining Screws
2. Pop up the plastic locking pins using a
flathead screwdriver.
3. Pull out the cable lock, and remove
the belt.
3. Remove the Nut A.
Nut A
5. Loosen the Bolt B.
Bolt B
4. Remove the Nut A.