MUTOH ValueCut VC2-1300 - The Tool Carriage Does Not Move Up;Down; Some Unexpected Lines Are Plotted; The Cutting Force Is Not Applied Correctly

MAINTENANCE MANUAL
VC2E-MM-00
58
The tool carriage does not move up/down.
[Check item] [Action]
 Is the blade holder installed properly? Refer to user’s guide and reinstall the holder.
 Is the flat cable damaged? Replace the flat cable.
 Is the carriage board damaged? Replace the carriage board.
 Is the carriage damaged? Replace the carriage set.
 Is the encoder of carriage damaged? Replace the carriage set.
 Is the driver damaged? Replace the main board.
 Is the linear bearing shaft of carriage rusty? Replace the carriage set.
Some unexpected lines are plotted.
[Check item] [Action]
 Is the blade holder installed properly? Refer to user’s guide and reinstall it.
 Is the media warp? Or are there some bubbles? Re-load the media or replace if needed.
 Is the vacuum fan working? Replace the fan or main board.
 Does the tool carriage move up/down? Please refer to the previous item.
 Is the output command HPGL or HPGL/2? Ask your software agent for help.
 Are there some communication errors? Check the communication protocol.
The cutting force is not applied correctly.
[Check item] [Action]
 Is the cutting force set properly? Reset the cutting force on panel or with command.
 Is the blade length out of the holder too short? Re-load the blade and readjust.
 Does the cutter holder move smoothly? Change the carriage set.
 Is there any problem on the holder encoder? Change the carriage set.