102 Menu 6: Sleep Mode
When you are not using the printer, always leave the power on and put the printer into the sleep mode while not in use. If you
do not put the printer into the sleep mode, the ink inside the printer could settle out and/or coagulate, causing poor image
quality or printer failure.
Sleep Mode 2: Start
Important!
• When you may not be able to run a weekly cleaning on the printer that is in sleep mode:
Perform "Longstore" and then power off the printer. It allows you to store the printer for up to one month (30 days).
"Long-term storage" P. 150
• If the printer is going to be in Sleep mode for more than 1 week, follow the steps below to perform daily maintenance once a
week.
• Invert the ink bags back and forth to agitate ink.
"Agitating ink" P. 115
• Wake the printer from sleep mode.
• Perform a nozzle check to see if there are no nozzle missing.
Put the printer into sleep mode.
• Tap .
• “Sleep Mode Start -> Enter” is displayed.
Tap (Enter).
• “In Sleep Mode Wake up -> Enter” is displayed.
The sleep mode will start.
• To exit the sleep mode, tap (Enter).
Important!
During Sleep Mode, even if the set amount of time has passed, print-head cleaning is not performed under the following
circumstances.
• When the front cover is open.
• When the maintenance cover is open.
• The pressure rollers is released.
• The waste ink tank is full.
• The high-capacity ink pack adapter has been removed.
• The S/C card has been removed.
• The inserted S/C card is not the genuine S/C card, etc.
If one of the above conditions occurs during Head cleaning, cleaning is stopped.
When the printer returns to a normal state, Head cleaning is restarted.
To Next Page
Loading...
