Muton XPJ-1682D - Setup 4: Media Initial; Setup 5: Media Width; Setup 6: Output Mode

Menu 1: Setup 77
Setup 4: Media Initial
Sets whether to detect the media width while initializing the media.
Setting values
The media will not be detected.
Detect the media width and edge while
initializing the media.
Detect the media width while initializing
the media.
This is the initially set value.
Note
When “Media Initial menu” is set to “Off”, set the media width of the current media in Media Width menu.
Setup 5: Media Width
Sets the width of the current media when the “Media Initial menu” is set to “Off”.
When the “Media Initial menu” is set to “Width”, the detected media width will be
displayed.
Use or to enter the value, and tap (Enter).
Setting values
210 mm to <1,000 mm> to 1,625 mm
<> indicates the initial value.
Setup 6: Output Mode
Sets how the media is handled after printing.
Setting values
The Take-up Unit will not be used.
This is the initially set value.
Set when using the Take-up Unit.
Set when cutting the media
automatically.
"Setup 7: Method of Cut" P. 79
Setup 4
Media Initial
Media Initial:
Off
Media Initial:
Top&Width
Media Initial:
Width
Setup 5
Media Width
Media Width:
(210 - 1625) 1000 mm
Setup 6
Output Mode
Output Mode:
Off
Output Mode:
Take Up
Output Mode:
Auto Cut