Operating from Front panel 45
Cutting media
[1]
Check that the job has been printed.
• Tap (Cancel).
[2]
Tap (Enter).
• The printer will advance the media for the bottom margin and will cut it.
Note
• If the front edge of a new roll media is not straight, cut it before printing.
• When the media detection is set to “Off”, the printer does not cut the media automatically.
"Setup 4: Media Initial" P. 77
• When the Output mode menu is set to “Auto Cut”, the printer cuts the media automatically after printing.
"Setup 6: Output Mode" P. 77
• The cutter blade is consumable parts. Replace it when needed.
"Replacing Cutter" P. 138
To Next Page
Loading...
