Muton XPJ-1682D - Roll Length Manage4: Roll Length; Roll Length Manage5: Auto Scan

108 Menu9: Roll Length Manage
Note
• The printer may fail to scan if a remaining length management code has dirt or fold marks on it.
• In case your printer is unable to read the code even if this setting is ON, check that the following settings are set to “OFF” or “Auto cut”.
"Setup 4: Media Initial" P. 77, "Setup 6: Output Mode" P. 77
• In case the printer failed to scan the code, manually specify the Roll Length settings based on the remaining length management information printed in
text on the media.
"Setup 17: Roll Length" P. 84
Roll Length Manage4: Roll Length
Go to the "Roll Length" settings.
"Setup 17: Roll Length" P. 84
Roll Length Manage5: Auto Scan
The ON setting will automatically scan the remaining length management code
when
• the printer is powered on.
• you replace a roll media.
Tapping the (Cancel) key while scanning will cancel the scan.
When your printer scanned successfully, the following settings will be specified
in Roll Length automatically:
•Type of roll media
• Remaining roll length
"Setup 17: Roll Length" P. 84
Roll Length Manage4
Roll Length
Roll Length Manage5
AutoScan