Cleaning 131
Cleaning period:
• When print blurring and dot missing remain after head cleaning is done.
Preparation:
• Cleaning stick
Cleaning around the print head
Important!
During cleaning, please note the followings.
• Use a dry cleaning stick. A damp stick can cause damage to the print head.
• Do not touch the tip of a cleaning stick with fingers. Skin oil will damage the print head.
• Do not reuse a cleaning stick. Dust on the stick will damage the print head.
• This cleaning takes about 5 minutes. If it takes longer, the stick will get dry causing damage to the print head.
[1]
Put the printer into the CR maintenance mode.
"Putting the printer into the CR maintenance mode" P. 126
[2]
Open the front cover.
[3]
Open the maintenance cover on the left side.
[4]
Use the cleaning stick to remove the ink deposits or dust on the bottom of the carriage.
DO NOT touch the surface of a print head (yellow)
Clean this part (grey)
• Surface around print head (silver metal part)
• Print head guide (black plastic part)
※Clean the part between the print head and print head guide.
To Next Page
Loading...
