Menu 1: Setup 89
Setup 25: Gateway
Sets the gateway.
• Use to increase a setting value.
• Use to decrease a setting value.
• Use to move the cursor to the previous digit.
• Use to move the cursor to the next digit.
Tap (Enter) after entering each digit.
Setting values
0.0.0.0 to <192.168.1.254> to
255.255.255.255
<> indicates the initial value.
Setup 26: Header Dump
Sets whether to print the following information when printing.
• Data header
• Data dot number (printed only when Header damp setting is “On”)
• Printing date and time
• Printer serial number
• Firmware version
• Receiving time (printed only when Header damp setting is “Dump”)
• Receiving size (printed only when Header damp setting is “Dump”)
Setting values
Dump data is not printed.
This is the initially set value.
Dump data is printed after the original
image is printed.
Prints only damp data.
“Data dot number” is not printed.
Prints the last header dump.
If no history is available, “No Print Data”
will appear on the front panel.
Note
• The data will be useful when contacting technical support.
• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are printed on data header.
Gateway:
192. 168. 1. 254
To Next Page
Loading...
