Muton XPJ-1682D - Menu9: Roll Length Manage

Menu9: Roll Length Manage 105
4 Menu9: Roll Length Manage
Note
• "Roll Length Manage 1: Print" or "Roll Length Manage 2: Simple Print" requires at least 400 mm printable width. Before printing, make sure that there is
sufficient width on the media.
If printable width is less than 400 mm, your printer will not perform printing. Printable width on the media can be adjusted by changing CR origin and side
margin (left and right side margin) settings.
"Setup 5: Media Width" P. 77, "Setup 8: Origin" P. 80, "Setup 3: Side Margin" P. 76
• The Roll Length Manage menu will not be displayed if "Media Initial" is set to "Off".
"Setup 4: Media Initial" P. 77
• The Roll Length Manage menu will not be displayed if the media is not loaded.
Before replacing with another roll media, you can print the remaining roll length
information on the roll media.
This information can be printed with a code that your printer can read. The next
time when the roll media is loaded, your printer will read the code and will
automatically specify the Roll Length settings.
Submenu
"Roll Length Manage1: Print" P. 106
"Roll Length Manage2: Simple Print" P.
106
"Roll Length Manage3: Scan" P. 107
"Roll Length Manage4: Roll Length" P.
108
"Roll Length Manage5: Auto Scan" P.
108
Menu 9 : Roll Length Manage
Menu 9
Roll Length Manage
Roll Length Manage1
Print
Roll Length Manage2
Simple Print
Roll Length Manage3
Scan
Roll Length Manage4
Roll Length
Roll Length Manage5
AutoScan