EasyManua.ls Logo

Muton XPJ-1682D - Error Message Display and Remedies

Muton XPJ-1682D
180 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
160 Messages and Error Messages
This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error messages on the front panel and stop
operation.
Error message display and remedies
Display Description
Cover Open Any or all of covers (front cover, maintenance cover right, maintenance cover
left) are open.
Close the cover.
Put Lever Back The pressure rollers is released. Lower the pressure rollers.
Hold Media The media is not loaded.
Load the media.
"Loading a roll media" P. 22
Undefined Media Media detection has failed. (Stops operation)
Reload the media.
Media Slant Media is fed obliquely. (Stops operation)
Reload the media.
Media Cut Error The media was not cut. (Stops operation)
Change Head Gap ***
PG: *** W: ****mm
The head height on the printer does not match with the one specified on the
print data.
"Changing the Head Height" P. 39
End Of Roll The Media has run out. (Stops operation)
Load a new media.
"Loading a roll media" P. 22
[******] No Cart. High-capacity ink pack adapter is not inserted. (Stops operation)
Insert high-capacity ink pack adapter.
[******] Ink Low Slot * ink is low.
Get a replacement bag ready.
[******] Ink End The ink bag has run out of ink. (Stops operation)
Replace both the ink bag and the S/C card with new ones.
"Replacing ink bag" P. 118
[*******] Discharged Ink is not filled.
Perform initial ink charging.
"Performing initial charging after head cleaning" P. 154
Full WasteInkTank The waste ink tank is full. (Stops operation)
Immediately empty the tank.
"Emptying waste ink tank" P. 121
[******] S/C ReadErr Reading S/C Card has been failed.
Insert S/C Card again.
[******] S/C Col.Err High-capacity ink pack adapters are inserted in wrong slots.
Insert high-capacity ink pack adapters correctly again.
[*] S/C Ink Err The ink bag cannot be used for this printer.
Contact your local MUTOH dealer.
[*] S/C CodeErr Inserted ink bag is not a proper one.
Contact your local MUTOH dealer.

Table of Contents

Related product manuals