Messages and Error Messages 161
[*] S/C Ink Low Slot * ink is low.
Get a replacement bag ready.
[*] Broken Chip S/C Card has been broken.
Insert new ink bag.
[******] Check Ink High-capacity ink pack adapter is not correctly detected.
Insert high-capacity ink pack adapter again.
If there is still no improvement, contact your local MUTOH dealer.
Cannnot Operate
Outside Print Area
The printer is unable to print because there is not enough printable width on
the media.
Adjust printable width by changing CR origin and side margin (left and right
side margin) settings.
"Setup 5: Media Width" P. 77, "Setup 8: Origin" P. 80, "Setup 3: Side
Margin" P. 76
Printable width needed varies depending on the types of test print. Adjust
the above settings to secure enough width.
"**>2: Adjust Print>" P. 62 (at least 550 mm)
"**>3: PF Adjust" P. 68 (at least 400 mm)
"Test Print 5: Adjust Head" P. 95 (at least 550 mm)
"Roll Length Manage1: Print" P. 106, "Roll Length Manage2: Simple
Print" P. 106 (at least 400 mm)
Cannnot Operate
Media Initial - Off
The printer is unable to display the "Roll Length Manage" menu because
Media Initial is set to "Off".
"Setup 4: Media Initial" P. 77
Switch Media Initial to "Top&Width" or "Width" and then select "Menu 9 Roll
Length Manage".
"Menu9: Roll Length Manage" P. 105
Cannnot Operate
No Media
The media is not loaded.
Load the media.
"Loading a roll media" P. 22
Cannnot Operate
Roll Length - Off
The printer is unable to print because the "Roll Length" setting is set to "Off".
"Setup 17: Roll Length" P. 84
Specify the "Roll Length" settings and then select Print or Simple Print.
"Roll Length Manage1: Print" P. 106, "Roll Length Manage2: Simple
Print" P. 106
Cannnot Operate
Output Mode - Take Up
The printer is unable to scan because Output Mode is set to "Take Up".
"Setup 6: Output Mode" P. 77
Switch Output Mode to "Off" and then select the Scan menu.
"Roll Length Manage3: Scan" P. 107
• "***" in the message “Change Head Gap ***” represents the head height (High, Mid, or Low).
• [*******] in the error message indicates the target ink slot.
• If “Ink End” or “No S/C Card” and “No Cart.” occur at the same time, “No Cart.” message has priority to be displayed.
Display Description
To Next Page
Loading...
