162 Messages and Error Messages
When the following message is prompted on the operation panel, a smartchip error such as broken chip may have occurred in
the S/C card.
Check that the correct color is inserted in the slot and perform smartchip recovery.
This will allow you to continue to print.
To perform smartchip recovery, do one of the followings according to the message appeared.
Note
• [*] in the error message indicates the target ink slot.
• During smartchip recovery execution, the ink slot being recovered blinks in the ink status menu.
"Setup 16: Ink Status" P. 84
Smartchip recovery
Display Description
[********] S/C Recog. E The S/C card that needs smartchip recovery may have been installed.
Remove the S/C card and insert it again.
If the printer is still unable to read it, insert a new S/C card.
• If a message “[**] Check Color OK ->Enter” appears after the S/C card is
reinserted, follow the message “[**] Check Color OK ->Enter” to operate.
[**] Check Color
OK ->Enter
The S/C card that needs smartchip recovery may have been installed.
Check that the ink color of the S/C card inserted is correct.
• In case of wrong color insertion, insert a correct S/C card.
• If color is correct, tap (Enter). The printer will perform smart chip
recovery and will continue to print.
[*] Chg. S/C Card The ink bag that smartchip recovery was performed has run out of ink.
Replace with a new S/C card.
To Next Page
Loading...
