118 Checking ink and replacing ink bag
When the ink level becomes low, the error LED of the front panel flashes and a buzzer sounds.
When an ink bag runs out of ink, the error message [Ink End] or [S/C Ink End] appears on the panel with blinking error LED and
beep sound. Replace an ink bag immediately. The printer will not resume printing until the ink bag is replaced.
When it becomes time to replace ink bag
[1]
Tap (Enter).
• The buzzer stops.
• In the figure to the left, the slot 4 ink bag is nearing replacement.
[2]
Prepare the replacement ink bag.
Replacing ink bag
Wear protective equipment (gloves, goggles or eye protection, protective mask, protective clothing) when
handling ink.
Be cautious that ink does not get into your eye or make a contact with your skin.
When ink gets into your eye or make a contact with your skin, wash with water immediately. If left as it is,
it may cause red eye or light inflammation. If it is necessary, please see your doctor immediately.
Important!
When replacing ink bags,
• make sure to remove the high-capacity ink pack adapter from the ink slot and then replace with a new ink bag.
• also replace the S/C card with a new one supplied with an ink bag. Otherwise ink level in an ink bag will not be detected correctly.
If ink bag is moved from cold to warm place, leave it in the room temperature at least three hours.
If you do not have any replacement ink bag, do not remove the empty ink bag from the printer.This may cause the nozzle clogs.
[4] S / C Ink Low
PG: Low W: 1625 m
To Next Page
Loading...
