68 Menu 1: Setup
Automatic PF adjustment method:
1. Select " PF Adjust 6: Auto".
•The printer automatically performs a PF adjustment.
•If the print defect persists after automatic PF adjustment, perform manual PF adjustment.
"Manual PF adjustment method using adjustment print." P. 69
**>3: PF Adjust
Sets up various settings on the Media feed correction.
When the following defects are found in printing results, they may improve by
conducting a media feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
"PF Adjust 1: Initial Print" P. 70
"PF Adjust 2: Initial Change" P. 70
"PF Adjust 3: Confirm Print" P. 71
"PF Adjust 4: Micro Print" P. 72
"PF Adjust 5: Micro Change" P. 72
"PF Adjust 6: Auto" P. 72
Note
"PF Adjust" requires at least 400 mm printable width. Before printing, make sure that there is sufficient width on the media.
If printable width is less than 400 mm, your printer will not perform printing. Printable width on the media can be adjusted by changing CR
origin and side margin (left and right side margin) settings.
"Setup 5: Media Width" P. 77, "Setup 8: Origin" P. 80, "Setup 3: Side Margin" P. 76
** : PF Adjust 1
Initial Print
** : PF Adjust 2
Initial Change
** : PF Adjust 3
Confirm Print
** : PF Adjust 4
Micro Print
** : PF Adjust 5
Micro Change
To Next Page
Loading...
