Muton XPJ-1682D - Page 74

74 Menu 1: Setup
**>7: Vacuum Fan
Selects the vacuum level.
Use or to select the value, and tap (Enter).
• If you are using a thin or delicate media and there is risk of it wrinkling due to the fan,
set a lower value for the fan.
Setting values
Low / Medium / <High> / Ex High
<> indicates the initial value.
**>8: Thickness
Sets the thickness of the media you are using.
Use or to enter the value, and tap (Enter).
Setting values
80 μm to <170 μm> to 2,800 μm
<> indicates the initial value.
Note
• This menu is to automatically adjust print quality to a certain extent. If you want to improve print quality, manually adjust it.
"**>2: Adjust Print>" P. 62
• If you have adjusted the print settings, you do not need to configure the thickness of the media in this menu.
**>9: Copy User Type
This is for copying the currently selected User Type setting into another User
Type.
The items that will be copied are:
• “Print Mode”, “Effect”
• The adjustment value for “Adjust Print”, “PF Adjust”
• The setting value for “Pre Heater”, “Platen Heater”, “Dryer”, “Vacuum Fan”, and
“Thickness”
Setting values
Here you can select the User Type to copy
the settings into.
If you select ALL, the settings will be
copied into all the User Type.
Type ** : 7
Vacuum Fan
** : Vacuum Fan :
High
Type ** : 8
Thickness
** : Thickness :
170 µm
Type ** : 9
Copy User Type
** : UserCopy :
Type ** -> 1
** : UserCopy :
Type ** -> ALL