Ramp 115
NOTE: Your vehicle may also be equipped with a Ramp
Deploy switch located on the pillar between the right side
front and rear doors, so the ramp can be deployed from
inside the vehicle. This switch will deploy the ramp to the last
used ramp length setting on the door switch.
• As the OUT portion of the Ramp Deploy switch is held,
the ramp will deploy and an audible chime will sound. If
three chimes sound and the ramp does not deploy, power
to the ramp has been turned off. Restore power by press-
ing the Ramp OFF switch in the center console.
NOTE:
The ramp will stop deploying if you release the
OUT rocker switch or press the IN rocker switch.
• As the ramp is deploying, it will extend out of the vehicle
horizontally and drop to the ground near the end of the
long ramp deployment. This allows the ramp to facilitate
loading to uneven ground, sloped terrain, and various curb
heights and locations relative to the vehicle.
DO NOT deploy the ramp in any conditions or areas where
wheelchair loading or unloading cannot be safely performed.
REASON: Loading or unloading in areas where the
ramp is not stable could cause serious personal injury or
death.
• Near the end of ramp deployment, fences will swing up on
both sides of the ramp to help prevent wheelchair run-
off.
To Next Page
Loading...
