Myray hyperion X9 - PC Installation and 2 D;3 D Calibration; System Requirements

27
EN
hyperion - TECHNICAL MANUAL
CONTENTS
2. PC installation and 2D_3D calibration .................................................................................................................................29
2.1 System requirements........................................................................................................................................................29
2.1.1 MAIN “FULL 3D” Workstation. Compulsory requisites for PC connected directly to a unit with 3D
(Cone Beam) module ...........................................................................................................................................29
2.1.2 Compatible video cards for “3D Full”(*) ................................................................................................................29
2.1.3 Minimum requisites for PC connected to PAN/CEPH/DTS, NNT station and Main Workstation for 3D ready
(No Cone Beam) unit only. ...................................................................................................................................29
2.2 PC X9 (3D FULL – Cone Beam) Installation ....................................................................................................................30
2.2.1 Preliminary tasks ..................................................................................................................................................30
2.2.2 Operating system settings....................................................................................................................................30
2.2.3 Extend single process memory limit .....................................................................................................................34
2.2.4 Disablingwindowsrewall ...................................................................................................................................36
2.2.5 “Intel Pro 1000” network card installation .............................................................................................................38
2.2.6 NNT software installation .....................................................................................................................................39
2.2.7 Library installation for PLEORA per Intel Pro 1000 ..............................................................................................43
2.2.8 Flat Panel (CBCT) driver installation ....................................................................................................................46
2.2.9 Connection beetwen PC and X9 ..........................................................................................................................48
2.3 X9 2D Calibration .............................................................................................................................................................56
2.3.1 Preliminary actions ...............................................................................................................................................56
2.3.2 Column calibration ...............................................................................................................................................59
2.3.3 PAN x-ray alignment ............................................................................................................................................62
2.3.4 PAN sensor calibration .........................................................................................................................................70
2.3.5 PAN mechanical alignment ..................................................................................................................................71
2.3.6 Laser test .............................................................................................................................................................73
2.3.7 Ceph x-ray alignment ...........................................................................................................................................74
2.3.8 Ceph sensor calibration .......................................................................................................................................80
2.3.9 Ceph mechanical alignment .................................................................................................................................82
2.3.10 Nasion calibration.................................................................................................................................................85
2.3.11 Calibration backup ...............................................................................................................................................88
2.4 3D Calibration ...................................................................................................................................................................94
2.4.1 Beam Limiter Test ................................................................................................................................................94
2.4.2 Daily Check ..........................................................................................................................................................99
2.4.3 Cylindrical test phantom acquisition (“Mattarellum”) ..........................................................................................101
2.4.4 3D calibration backup.........................................................................................................................................105
2.4.5 QA Phantom Scan .............................................................................................................................................107