Myray hyperion X9 - X9 2 D Calibration; Preliminary Actions

56
EN
hyperion - TECHNICAL MANUAL
2.3 X9 2D Calibration
2.3.1 Preliminary actions
The 2D calibration kit consists of the following objects:
-Aluminiumlter
- Laser guide
- 2D test phantom
- Octagonal support
- Ceph calibration plate (present in every package of the ceph arm)
Launch the NNT software, enable the Service Mode (“CTRL+ALT+SHIFT+END”).
Click on the button at top right and select “Launch 2D Calibration”.
Select“Service”mode,password:cea