ABSYNTH 5 Reference Manual – 111
You have the sme optins for editing the two waveforms as with sSimple wWaves: You can edit
the individual waves oftage., by switching between the two waveforms using Use the Morph
Wavd Morph Wave 2 buttons from the Waveform pagein the tab bar to switch between the
waves.
Waveform page in Wave Window
In the Morphing page you determine, how ABSYNTH 5 merges both waveforms into a single one.
► Click the Morph tab, to go to the Morph page.
The Wave Display in this view is divided horizontally into three sections: At the top you can
see Wave 1, in the middle Wave 2, and at the bottom you see the resulting Wave.
Morph page in Wave Window (only available for Morph Waves)
1. The morphing takes place in two parallel processes: Transition contro is rephe mix mor-
phing ratio ofph to Wave 2. At a 0 value only Wave 1 i 1 only;, at the value of 100 only
wave 2 is activeby raising the value, Wave 1 gradually waveforms is to set the Transition
control to 50%.
To Next Page
Loading...
Need help?
General