ABSYNTH 5 Reference Manual – 95
6.5.1 Parameters
Master Section
•
Beatswitch: With the Beat switch you select whether the value in Time control should be
indicated in seconds (Sec) or in beats (Beat), ie in quarter notes.
• MasterTimecontrol: Determines the maximum delay of the three taps.
• MasterFeedbackcontrol: Denes the feedback intensity.
Echo Section
• Timecontrol: Determines the delay of each echo (in percent) relative to the value set in
Time control in the Master section
•
Sensitivitycontrol: Changes the impact of the control signal (received via Macro Control)
on the echo’s Time control (in percent), by the value you set.
•
Lowpasscontrol: Determines the cut-off frequency of the Lowpass lter that is applied to the
signal in the feedback loop. The value in Lowpass control can range from 1.0 to 22050 Hz.
• Highpasscontrol: Determines the cut-off frequency of the Highpass lter that is applied
to the signal in the feedback loop. The value in Highpass control can range from 1.0 to
22050 Hz.
• Allpasscontrol: Determines the cut-off frequency of an Allpass lter, which is similar to
the Allpass 4 function in the Filter Module in the Patch Window. Allpass lters let all
frequencies pass through, but change the signal’s phase depending on the lter frequen-
cy. The Allpass lter produces its most impressive results when the parameters are
modulated, thus creating phasing effects.
•
Gaincontrol: Denes the output signal’s level of the respective echo (in dB). A value of
-6dB reduces the signal level by half.
•
Pancontrol: Positions the respective echo signal in the panorama of the output signal. A
0 value corresponds to a position at the extreme left, 1 a position at the extreme right
and 0.5 to the middle.
•
Feedbackcontrol: Sets the level of an echo’s signal, which is routed back to the input, as
a percentage of the original signal’s level.
To Next Page
Loading...
Need help?
General