ABSYNTH 5 Reference Manual – 64
To activate a Filter module, do the following:
1.
Click on the extended left margin on a Filter, Modulator or Waveshaper Module Slot to
activate it.
2.
Choose one of the lter types from the Type menu (the rst and biggest group in the
menu).
5.5.2 Filter’s Panels and Tabs
Like all other modules, a Filter module can have up to three panels organizing the various
module parameters. Each panel can be called by clicking on the corresponding tab at the
top of the module.
The available panels depend on the type of lter. You will nd a complete list of available
panels in the module-specic sections below. But we can already give here two basic rules
for these panels:
• All lter types but the Cloud offer a Main panel as rst panel, holding the main param-
eters for that lter type.
•
The lter types LPF 2 Pole, LPF 4 Pole, LPF 8 Pole, Allpass 2, Allpass 4, Allpass 8 and
Supercomb have an additional FB panel controlling the new feedback loop introduced in
ABSYNTH5 for these lters (see next section).
5.5.3 Feedback Loop and Feedback Panel
ABSYNTH 5 introduces a new functionality to some of its Filter modules: a feedback loop.
This feedback loop allows you to send a portion of the lter’s output back to its own input…
without forgetting to further process the signal on the way! The feedback loop is available
for following lter types: LPF 2 Pole, LPF 4 Pole, LPF 8 Pole, Allpass 2, Allpass 4, Allpass
8 and Supercomb.
For all of these lter types, the feedback loop settings are located on the Feedback panel
(labeled FB), next to the Main panel:
To Next Page
Loading...
Need help?
General