ABSYNTH 5 Reference Manual – 93
6.4.1 Parameters
Master Section
•
Beatswitch: With the Beat switch you select whether the value in Time control should be
indicated in seconds (Sec) or in beats (Beat), ie in quarter notes.
• MasterTimecontrol: Determines the maximum delay of the three taps.
•
MasterLowpasscontrol: Determines the cut-off frequency of the lowpass lter, which the
feedback signal runs through (in Hz).
Tap Section
•
Timecontrol: Determines the delay of each respective tap in percent of the value se-
lected in the Time control in the Master section.
•
Sensitivitycontrol: Denes the impact of the control signal received via Macro Control on
each tap’s Time control (in percent).
• Inversionswitch: Turning on the Inversion switch inverts the impact of the control signal
received via Macro Control.
•
Gaincontrol: Denes the signal proportions for each tap at the output in dB. For example,
a value of -6dB reduces the level by half.
•
Pancontrol: Positions the respective tap’s signal in the panorama of the output signal. A
0 value corresponds to a position at the extreme left, 1 to a position at the extreme right
and 0.5 to the middle.
•
Feedbackcontrol: This parameter exists only for the rst Tap. It regulates the level of the
signal, which is re-routed to the input, as a percentage of the original signal’s level.
To Next Page
Loading...
Need help?
General