ABSYNTH 5 Reference Manual – 149
10.5.2 Volume
Here you can set how ABSYNTH 5 uses incoming information from a volume pedal or another
MIDI control source as a level control.
•
CCcontrol: Here enter the number of Controllers that you want to use for control of the
entire level; in the standard setting, ABSYNTH5 reacts using Control Change #7, desig-
nated in the MIDI specication the control of the total level.
•
Pre/PostToggle: Determines whether changes in the level should come before or after
the Master Channel.
•
MacroControlmenu: If you want to make the entire output level dependent upon the
signal value of a Macro Control, you can select a Macro Control from the Macro Control
menu.
•
Depthcontrol: Determines the strength with which the incoming control information inu-
ences the level.
•
Lag: Establishes the delay before ABSYNTH 5 reacts to changes in the signal value re-
sponsible for the level control.
10.5.3 Pan
Macro Controls 15 and 16 (both of which are combined with an XY control) are designed
to control the Panorama Position by simultaneously placing the output signal on a left-right
axis and front-back axis. In order to use a two-axis controller like a joystick or a touch pad to
adjust the panorama position, learn the instrument as described in section 10.3 “Controllers
Page”. For control of the Panorama you can also determine the strength of the control signal
(Depth control) and the hesitation in the assessment (Lag control).
To Next Page
Loading...
Need help?
General